tsl

  1. ThingFish

    Switching from Gain to Clean Sags Volume

    Hi Guys- I'm working on a TSL 122 JCM 2000 Combo. I replaced the main board with the new Rev "non thermal" board, retubed, and conservatively set the bias. The amp sounds great, no issues after many hours of long rehearsals. However, when switching from either gain channel back to clean...
  2. R

    Preamp Pedals and TSL602

    Hi there I have been interested in preamp pedals recently like the Diezel VH4 one or the Victory Preamps. I also keep seeing conflicting information on how the Effects Loop on the TSL602 works (FX Level knob at max = Series and so on.) What I basically want to know is whether I can use the...
  3. Rory.B.Bellows

    Midi Mod for jcm2000 tsl100

    hi guys i have a Behringer FCB1010 Foot Controller and i want to use it to change the channels on my tsl100 head! is there a mod out there to make the tsl100 midi controllable? this possible??
  4. Rory.B.Bellows

    TSL 100 new rev20 pcb help!!

    Hi guys i pickup up a old tsl100 that had a bad hum on clean channel and just been a gig pig for the last 10years without a service, so i got new tubes a new rear board cos all the loop input were smashed and upgrade the main pcb to the rev20 model. the installs went well (the inside was actual...
  5. Kutt

    Rocker switch replacement - Discharge caps?

    At some point soon I'm planning on replacing the power rocker switch on a JCM 2000. I know it's best practice to always discharge caps. My specific question is this- Is it a guarantee you'll get bitten if you do not discharge them while replacing the switch?
    • Kutt
    • Thread
    • dim dsl flicker jcm 2000 light power switch tsl
    • Replies: 17
    • Forum: The Workbench
  6. U

    Marshall TSL602 noise reverb

    Hi all, this is my first post, until today I usually find the solution reading your messages but this time I have not found solution for this specific problem. I have a Marshall JCM2000 TSL602 from 2004 (I am the first owner). With reverb on at both channels, when I switch from crunch or lead...
    • U-mass
    • Thread
    • 602 jcm2000 marshall noise reverb tsl tsl602
    • Replies: 5
    • Forum: Marshall Amps
  7. Goldguitarguy

    Jcm 2000 Tsl 601 Switching Issues

    Hey guys and gals Long time creeper, first time poster! I'm not new to amp repair but I would still be considered a novice of sorts, I suppose. But this TSL has me stumped now... So the long story short is the TSL 601 wasn't working period when I got it. No sound through any channels, no...
    • Goldguitarguy
    • Thread
    • amp repair crunch gain jcm 2000 marshall switching issue tsl
    • Replies: 169
    • Forum: The Workbench
  8. 6StringStewie

    Whiskey On My Breath (devil At The Door) - Intro Demo

    Hey Gang, Sharing my first session recording of the intro to a song I am working on Called "Whiskey on my Breath (Devil at the Door)". It's a little rough in spots as this is my first recording attempt. Listen here. Any feedback on how the lead and rhythm guitar tracks sound would be...
  9. D

    Tsl60 And Tubes....

    Hey Guys, First post, long time lurker. I'm looking at rolling a few tubes through my TSL60 (601 converted to a head) to see what I can get out of it. I have JJ's in the power tubes but am yet to touch the preamps (After 11 years). I mostly play on the crunch channel at 7 on the gain with a...
  10. T

    Tsl Diy Footswitch Mod Help

    Hi, first post here: Based on some members on this forum suggestions regarding TSL footswitch diy mod, I cannot seem to switch between crunch and lead. With both buttons pressed in on the amp, I can only switch between clean to whichever OD mode it is set to by shorting pin 1 to pin 6. When...
  11. Rogueleader

    What Tubes Should I Buy???

    I recently bought a used jcm 2000 tsl 122. It is actually shipping now. Even though the seller says everything is in perfect order, I’m planning on replacing all tubes as soon as it gets home. I looked into the specs and says that it uses EL34s (svetlana), my question is which ones should I buy...
    • Rogueleader
    • Thread
    • 12ax7 el34 hardtube jcm 2000 marshall mediumtube softube svetlana tsl tubes
    • Replies: 10
    • Forum: The Workbench
  12. D

    Marshall Jcm 2000 Vs Mini Jubilee

    Hi folks, its time for me to buy a new amp, since i am quite bored with my Laney GH 50 (jcm800-ish circuit). I have the oportunity to buy myself a used 1998 JCM2000 DSL 100 or a b-stock Mini Jubilee 2525H head. I play mosty hard rock, ska-punk rock and a little bit of stoner rock. I can not...
  13. W

    Marshall 1960a 4x12

    [Kent, England] I'm thinking of selling my cab, it's in very nearly perfect condition (a few marks near the bottom of the cloth). Hardly used, as most practices I was able to just use the cab in the studio. It's been used lightly at home and never gigged. I think it's just too much amp for me...
  14. Rds

    Tsl 122 Issue

    Hey thanks for looking. My problem is my tsl intermittently sounds much louder and way more overdriven when I turn it on, then after a few minutes it will revert to the normal sound of the amp. Almost like a switch was switched. It sounds like way more power when this happens. I actually like...
  15. S

    Need A Hand Written Diagram To Make A Tsl Footswitch

    anyone out there made a footswitch for there tsl , I have a jcm2000 tsl60 head and would like to make my own footswitch ive seen the 6 pin connector diagram but was wondering how you would get separate switching for channel, crunch, and lead , reverb and fx I know

Latest posts



Top