ST1 amp board question

[hitbyastick]

Amp is 2203X.

I need to get to the underside of the board to properly solder a wire to where the phase inverter is located. After removing the standoff nuts, I can't see how one could flip or even lift the board to access the underside. Seems to be impossible. I know I would likely have to desolder components here and there and remove pots and so forth. I'm just wondering how you guys have done it.

Thanks

 

[StingRay85]

Removing the pots from the chassis is the way forward

 

[hitbyastick]

thanks again