The heater voltage for preamp tubes
For v1 and v2 is 7.4 DC
For the v3 and v4 7.3 AC
the power tubes have no pin numbers and are hard to reach not shorting something, will try tomorrow one more time
I uploaded a video with both channels, a creepy smartphone mic was unable to pick the lower...
I checked every soldering on the PCB, and unplugged and plug again every wire, but nothing really helped
I suppose some capacitor or resistor has died but still looks new
For measuring plate voltage I used pint 6 and 1 to the ground
For measuring cathode voltage I used pint 8 and 3 to the ground
Then for getting the voltage between the plate-cathode, I used pins 6 to 8, and 1 to 3 for each tube
For current, I used the exact same amper-meter, dial on a 20m...
I don't think this is a bias issue, I have checked bias is stable during a couple of hours of playing
also, the green channel works as expected, so there is a problem somewhere on preamp side
Unfortunately found VERY good amp guy it's a lottery, I had a negative experience with some tech who created a mess of soldering in the amp and fixed nothing
I used to fix all my previous amps by myself, but this one is much more complex than a single-channel one like Orange tiny terror
I...
In my case, it sounds like a wah-wah pedal, with no lows at all, even a deep switch doesn't add low at much if the issue is the same, it might be because of lack of gain
Hi folks,
I recently bought my first Marshall the JCM 2000 DSL 50.
I have spent a few days, playing around with it, switching between channels and mods, trying to pool all possible sounds from it.
Some moment, when I was playing on a red channel Lead 1, the gain suddenly disappeared, the...
To be more clear, I used one spare tube for testing, I put it in each position checking the result each time
The only difference is the new tube is high gain one, it adds some gain but still does not fix the problem
The red channel is supposed to be more hot-roaded than the green one, but in...
I have Dimarzio PAF's 36th anniversary set on my guitar, it has pretty low output pickups, for Lead 1 I've used the Boss SD 1 just for volume booster, and a bit of an EQ correction
Yes, this is the first that I did, I mixed them up, then put a new, high-gain one in the v2 - nothing really helped
The result, is still the same, the lead 1/2 loss a gain, a bit of volume, and a lot of lows, it sounds like a wah-wah pedal
Hi everyone,
Recently I purchased my first Marshall amp, the JCM 2000 DSL 50
But my happiness didn't last long.
A few days ago, something went wrong.
I was playing on a bedroom level, a volume of about 2/2.5, a gain of 10, on a lead 1 red channel boosted by the Boss SD 1, suddenly all gain...