Oh wow!!! Thanks for all you responses!
Certainly got a load of home work to do. Currently on holiday so trying my best to answer things from afar
Wait I just realised does it need to go to ground of the chassis first and then the filter cap?
If so I havent done that 🙃 that means in theory I...
Thanks for your responses
Resistance fully anti clockwise is : 78.6k OHMS
Fully clockwise it is: 55.5k OHMS
Does this mean anything? Guess it makes sense as the pot is 25k OHMS
Thanks here are the restults
Resistance
1- 222k (Upper left)
2- 14.4k (bottom)
3-55.6k (right)
all of which marry up to the wiriing diagram
Here are the voltages:
1. 353.3V
2. 257V
3. -169 V
4. -163 V
thanks for your continued help and patience
Also noticed I never need to discharge this cap
Great I’ll try that. Could you point me how to measure that reading? Not entirely sure what the centre tap is. Sorry still a complete noob
sure thing thank you!
Okay pin 5 and maximum negative voltage done
Put in tubes
Not clear but they glowed up great
Then I put a clip on the corner of pin 8
And … still nothing
Sorry I should have clarified. that was without tubes. Shall I try with tubes? I can garantuee ill have the same result
Yup definately grounded on pin 1
Fuse back in and it’s good. I got HT voltage
This is without tubes
And clipped on the 1ohm resistor
Again that’s nothing and that’s with the standby OFF so now really scratching my head. The tubes glow up and warm up fine too
Anyone got any ideas?
Good afternoon all.
I am back from my business trip so I have finally been able to sort the inputs. I did it as per the new schematic that you all suggested.
I started it up and nothing went bang which is good. I did establish HT voltage which was a stable 320v
However no luck on...