• We are looking to make improvements to the Classifieds! Help us determine what improvements we can make by filling out this classifieds survey. Your feedback is very appreciated and helpful!

    Take survey

channel

  1. ThingFish

    Switching from Gain to Clean Sags Volume

    Hi Guys- I'm working on a TSL 122 JCM 2000 Combo. I replaced the main board with the new Rev "non thermal" board, retubed, and conservatively set the bias. The amp sounds great, no issues after many hours of long rehearsals. However, when switching from either gain channel back to clean...
  2. J

    DSL401 very low volume on clean channel, OD1&2 fine

    Hello, Still trying to fix my mate’s DSL401. When it came to me it was completely dead. Fixed loads of problems, lot’s of badly soldered joints but main issue is that “someone” had wired the standby switch so it wasn’t connecting the wires I.e, both wires were on the same side of the...
  3. Del Rei

    Messing around with Plexi Channel of my Friedman Smallbox

    Hey, guys... Just a sloppy playing in this Saturday. Having fun. After some long time without touching the guitar, today I decided to have some fun. And now my fingers hurts... LOL
    • Del Rei
    • Thread
    • channel friedman plexi smallbox
    • Replies: 0
    • Forum: Other Amps
  4. K

    6100 LM Buttons in Crunch Channel!?! Help

    Hey Guys, it might be a stupid question, but I hope you can help me! I got an old 6100LM 100W head. I‘m not a newbie to amps and used many marshalls over the years, but the A,B and C Mode on the crunch channel confuses me. how do the two switches have to be switched, for mode A, B and C...
  5. Williamwolnka

    High Sensativity Is Dead 2204, Help!

    I noticed last night my amp was sounding anemic. Last week it was finicky at the high sensativity jack. Cutting in and out. I fired it up this morning and nothing. Low sensativity works. It is a horizontal input 2204 jcm800. What can I do? I have band practice on Tuesday!!!
  6. D

    Beginners Question - Mg100hcfx Channel Volume Problems

    Hello fellow guitarists, well, to begin with facts - I am kind of new to half-stack amps but needed to buy a MG100HCFX to be used instead of my Fender Mustang IV Combo which died last week. And here comes my problem: As soon as I turn this bad boy on I can control the master volume while my...
    • Dan A. Carter
    • Thread
    • channel gain head master mg100hcfx problem problem with amp volume
    • Replies: 2
    • Forum: Marshall Amps
  7. BluesForDan

    I Have Two Jcm2000 Dsl Footswitch Pedals

    One is from my former JCM2000 DSL401, a two button pedal that switches from the clean (green) channel to the dirty channels, and from dirty to downright filthy channel (yellow to red). I played 95% of the time on the green channel with only the rare foray into the yellow channel and I used the...
    • BluesForDan
    • Thread
    • channel dsl401 dsl50 footswitch jcm2000 marshall pedal
    • Replies: 2
    • Forum: The Tone Zone

Latest posts



Top