so I finally took the time over the weekend to install Matthews repop face plate on the 2204. while i was at it, I had purchased the newer turn type ohm selector. I installed as well (got tired of tape holding the old one on. while doing this I took some gut shots because, several things don't look normal to me. the two blue resistors that seem to skip a solder post where the 47K resistor location is? this may be normal but not sure what is supposed to go at location X680? there also seems to be at least one 68K if not two missing where the tannish wire is glued to the other resistor? and last but not least, the big rectangular resistor which I believe is on my presence knob? any of you guys can tell me if these are mods? or are correct or normal?
thanks
thanks