64Vibroverb
Member
Would like advice on the best way to proceed with an issue that p****d me off yesterday!
I'm building a '69 100w Plexi clone, stand up Heyboer PT. Everything seems to be going nicely until I added the board. The blue bias wire that connects to the board is at least an inch short. Hate the thought of splicing so best option seems to be a terminal strip. I'd actually use turrets.
So unless there's a better way should I terminate the unused PT leads here also? That would get rid of the bundled leads too. I've seen that on laydown trannies but never on a stand up.
Any ideas welcomed!
I'm building a '69 100w Plexi clone, stand up Heyboer PT. Everything seems to be going nicely until I added the board. The blue bias wire that connects to the board is at least an inch short. Hate the thought of splicing so best option seems to be a terminal strip. I'd actually use turrets.
So unless there's a better way should I terminate the unused PT leads here also? That would get rid of the bundled leads too. I've seen that on laydown trannies but never on a stand up.
Any ideas welcomed!