TSL60 cuts out between channels!?

[Richardjordan]

Hi,

My new TSL60 cuts out for half a second when changing from clean to crunch (but not from crunch to lead or visa versa).

This is a pain and surly shouldn't happen - none of my previous marshalls have done this and really didn't expect it from an obvious gigging rig.

Is there something that can be done to rectify this?

 

[maxxi]

its normal with a TSL, the delay is put in there intentionally so the reverb doesn't pop when you switch from clean to OD.

ive seen some topic on the net that claim to have reduced the delay time by changing some resistor values, but none of them stated they got rid of the delay

 

[Richardjordan]

ok thanks - ill look into it a bit.

 

[SkinnyJ]

Hmmm... I didn't notice that when I had mine.

 

[bolt22]

I didn't notice it on mine either??

 

[royslead]

I cant say mine does either (TSL602). Richardjordan - does the "delay" occur only when switching with the footswitch? Try switching channels without the footswitch plugged in.

 

[SkinnyJ]

Also, I forgot to mention that the footswitch on the TSL series amps has a reputation for being quirky.

 

[royslead]

Also, I forgot to mention that the footswitch on the TSL series amps has a reputation for being quirky.

...this is where I was leading to.