We are looking to make improvements to the Classifieds! Help us determine what improvements we can make by filling out this classifieds survey. Your feedback is very appreciated and helpful!
Yes I just tryed eljeffs settings and that helps.I might try to experiment with some different cabs.My freind has a mode 4 full stack.Im gonna try and snag a cab for the weakend.thanks Marshall Mann.BTW I also noticed that the more volume the better It sounds.Not a great low volume amp.I have a...
Yea I noticed that the more the preamp was turned up the darker and slightly muddier it got.My first reaction on a hig gain amp is to dime the preamp.Learning slowly that this is not always the best place on a high gain amp for tone.I'll try these settings.thanks.
Just wondering on some hints to make the bottom end of my 100wSLX a little tighter.I play an 100w SLX threw an 800 cab with 25w greenbacks.Tung sol 5881 tubes.Is there a cap I can experiment with or a different speaker/cab possibly?Bottom end seems a little flabby or mushy.Thanks for the...
Hey just a question to anyone who knows.I have a JMP that has the normal blue glow from the tubes.The amp is biased right.The question I have is that when I play the amp and watch the power tubes,the blue glow dissapears.then the blue glow comes back when I stop playing.Normal?These are KT88 tubes.
killervintage on ivanhoe in St Louis.Great tech.I think his name in Obed.Look up the website.They have alot of great stuff in there also,worth the trip.The Obed guy is the maker of reason amps.
Ok,so I looked at the schematic and took a ground wire from the ground buss that goes all the way across the rear of the pots and took it to ground.took the loud humming away.Now only vol 1 has some buzzing when turning it up loud,but that was there when I got it.any suggestions on that would be...
When I replaced the cap that the board covered there was only one wire going to ground,and that was the ground for the cap.No other ground was going to this point.Should I put a ground from the preamp cap to this point?This noise was an issue before the caps.I decided to replace the caps even...
Nope,the noise still stays ther with v1 out of the socket.Been pokin around a little bit with a chop stick and found when tapping any part of the v2 socket it makes a thumping sound.the other valve sockets do not do this.I willl probably get sone sockets and replace that 100k resistor going...
Ok,so Installed new filter caps 50 x 50 500. I had 3 of them.Not a real big deal,but the amp is doing the same thing.When I pull valve 2 the humm goes away.and the humm can be changed when moving vol 1 and vol 2 around.I checked the wire on pin 2 and found it had allready been done.The volume...
I will definetly look into the Wilder effects mod.As for putting the effects in at the mic source,that may be more complicated than I want.Exspecialy when there is limited amount of set up times between bands.
I recently sold my DSL 50 to get a jmp MKII.I like the sound better but I wasn't anticipating the different sound from my effects.DSL had a loop and thats what I ran delay/flange/chorus threw,sounded great.Now if I turn the mix up on the effects it drives the amp to hard and sounds horrible.I...