Quick Cabinet Ohm Question

[Cragworth]

i have just bought a JCM 2000 DSL 100w head but the cab I have is an AVT 4x12 one. The ohms rating on the AVT cabinet is 8ohms which I plug into the 8ohm input on the AVT head but the JCM only has a 16ohm input or 8/4 parallel jacks then there's an ohm selector switch 4/8ohms. Sorry if I'm being stupid here but desperate to try this out but not sure which inputs...
Cheers

 

[anitoli]

If the 4 is in parenthases (4) it means that is an 8 ohm tap providing it hasnt been switched internally to 4 ohm.
Most of the time it should be 8 ohms as most cabinets are not of the 4 ohm variety.

 

[mickeydg5]

Get or find yourself a DSL100 manual.

Set the amplifier impedance selector switch to 8 ohm and then plug a speaker cable into an 8 ohm amplifier output jack into the cabinet jack.

 

[Cragworth]

Get or find yourself a DSL100 manual.

Set the amplifier impedance selector switch to 8 ohm and then plug a speaker cable into an 8 ohm amplifier output jack into the cabinet jack.

So set the switch to 8ohms then plug into the 8ohm parallel path?

DSL manual:

http://www.amparchives.com/Amp Arch...Marshall JCM 2000 DSL50 & DSL100 Handbook.pdf

 

[mickeydg5]

Yes, it is in the manual.

 

[Jethro Rocker]

So set the switch to 8ohms then plug into the 8ohm parallel path?

DSL manual:

http://www.amparchives.com/Amp Arch...Marshall JCM 2000 DSL50 & DSL100 Handbook.pdf

Yep. Just as you said!!