Day 1...
Decided to use 5/8" chip board, kinda like what Marshall uses on their low-grade cabs.
Built out the face frame with 1x2 pine cut to size.
Dowels and glue and a clamp or two.
fashioned a rounded bottom lip from some 1/8" x 1 scrap laying around.
Front and back panel mounting strips from the 5/8" chip board.
Test fit on the front & back.
Rounded off the corners with the scarry 3/4" router bit.
Got the handle mounted & vent cut in the top.
Chassis bolts and sprung feet mounted.
Found some nice, expanded metal mesh ( $4 gutter leaf guard ) I'll put in that hole in the back after the tolex.
I had 2 size vents and decided to put the large vent in the top.
And a final assembly to try it out before I take it all apart again for the tolex.
That's all for today.
Time for dinner.
Decided to use 5/8" chip board, kinda like what Marshall uses on their low-grade cabs.
Built out the face frame with 1x2 pine cut to size.
Dowels and glue and a clamp or two.
fashioned a rounded bottom lip from some 1/8" x 1 scrap laying around.
Front and back panel mounting strips from the 5/8" chip board.
Test fit on the front & back.
Rounded off the corners with the scarry 3/4" router bit.
Got the handle mounted & vent cut in the top.
Chassis bolts and sprung feet mounted.
Found some nice, expanded metal mesh ( $4 gutter leaf guard ) I'll put in that hole in the back after the tolex.
I had 2 size vents and decided to put the large vent in the top.
And a final assembly to try it out before I take it all apart again for the tolex.
That's all for today.
Time for dinner.