- Joined
- May 11, 2024
- Messages
- 104
- Reaction score
- 77
Well my one worst nightmares happened while working on my JMP 2204…I lost a little bit of solder pad
In an attempt to eliminate the amount of time/heat I put on the board I tried using one of those electronic solder suckers. It did it’s job, but was just too much. Never again! (the rest of the amp is fine btw)
What’s the best step forward?
(Warning graphic images )
In an attempt to eliminate the amount of time/heat I put on the board I tried using one of those electronic solder suckers. It did it’s job, but was just too much. Never again! (the rest of the amp is fine btw)
What’s the best step forward?
(Warning graphic images )
Last edited: